The lathe consists of the metal lathe parts bed, headstock, gearbox, feed box, finishing rod, accessories, push bag, instrument relaxation, bed hips and legs and tailstock.
1. Bed: This is basically the basic part of the lathe and is usually used to support and place different areas of the lathe to ensure its comparable location, such as bedside tables, supply bins, slide packs and many others. bed is plentiful
Rigidity and durability are high, and the bed surface precision is excellent to ensure the correct relative position between your factors. Four parallel manual side rails are found on the bed for proper movement in the large carriage (instrument rack) and tailstock according to the headstock. In order to maintain the surface reliability of the mattress, attention should be paid to routine maintenance when operating the lathe.
2. Spindle box: used to fix the spindle and make it rotate. The main shaft is a hollow frame. The front-end outer cone top is equipped with three-jaw bone chuck and other components to hold the workpiece, the front-end inner cone surface is used for the installation center, and the slender opening can pass through the long nightclub material. The spindle box of C6132 lathe has only one speed change, and its spindle speed change system is placed in the separate gearbox of the spindle to reduce the influence of vibration and heat generated by the transmission parts of the spindle gearbox.
3. Gearbox: The shaft of the equipment in the gearbox is driven to rotate by the motor unit, and other speeds are obtained by changing the position (mesh) of the gears in the gearbox, so the motion is transmitted to the main shaft through the main shaft. Pulley generation.
4. Feed Box: Often referred to as a gauge pack, it comes with a speed modification gear that provides motion, can modify the reference and pitch, and send motion to the fine bar or screw.
like:
留言列表
